For Qbus, any device (a light point, thermostat, weather station, etc.) is an output.
In the configuration section, you can activate Direct control.
If this feature is active, for certain outputs, after clicking on an output you will not see the screens below, and the output is going to respond directly to the click.
To call up the screens below, you then need to click a little longer on the exit.
Via the On and Off button, the lights are switched on and off.
With a dimmer, by sliding up and down on the lamp symbol, the lighting can be dimmed up and down.
The RGB output is used to drive RGB LEDs.
By moving on the colour circle the you can set a colour.
By sliding up and down in the right section, the LED luminaire can be dimmed up and down.
At the bottom you can:
The WWKW output is used to drive WWKW LEDs.
Sliding left or right on the wwkw bar sets the colour temperature.
By sliding up and down in the right section, the LED luminaire can be dimmed up and down.
The temperature displayed on the left is the room temperature.
The temperature on the right is the requested temperature.
On the bottom bar, the regime is adjusted: Manual, Frost, Economy, Comfort, Night.
A regime is a preset temperature value that can vary from room to room.
The set temperature can be adjusted by sliding up and down on the thermometer symbol.
Using the Open and Close buttons, it is possible to open or close the shutter.
The position can be adjusted by sliding up and down on the shutter symbol.
Via the Open and Close button, it is possible to open or close the screen.
The position can be adjusted by sliding up and down on the screen symbol.
You can use the horizontal shuffle bar to adjust the position of the slats.
Clicking Activate will execute the scene.
A scene can send a fixed value to all other Qbus outputs and to Ubie devices.
From this output, you can only read out the status.
These meters display the current values of your electricity meter.
Most outputs have a graph icon at the top right. Clicking on this will bring up the following window:
This window shows a live stream from your camera.
To use any of these functions, the respective service must be activated.
The configuration section discussed the options of outputs. For each output you wish to control with your voice, the opte Voice Control should be on.